Honda 2004 Odyssey Service Manual page 1180

9. Remove the brake disc from the knuckle.
10. Check the front hub for damage and cracks.
11. Remove the cotter pin (A) from the tie-rod end ball
joint, then loosen the nut (B).
B
12 x 1.25 mm
54 N·m
(5.5 kgf·m, 40 lbf·ft)
12. Remove the tie-rod ball joint from the knuckle using
the special tool (see page 18-10).
13. Remove the lock pin (A) from the lower arm ball
joint castle nut (B), and remove the nut.
A
07MAC-SL00200
14. Remove the lower ball joint from the knuckle using
the special tool (see page 18-10).
07MAC-SL00200
A
B
12 x 1.25 mm
59 69 N·m
(6.0 7.0 kgf·m,
43 51 lbf·ft)
15. Remove the damper pinch bolts (A) and flange nuts
(B) from the damper.
A
D
16. Pull the knuckle outward, and remove the
driveshaft outboard joint (C) from the knuckle (D)
by tapping the driveshaft end (E) with a plastic
hammer, then remove the knuckle.
17. Separate the hub (A) from the knuckle (B) using the
special tool and a hydraulic press. Be careful not to
distort the splash guard. Hold onto the hub to keep
it from falling when pressed clear.
B
A
B
16 x 1.5 mm
157 N·m
(16.0 kgf·m, 116 lbf·ft)
C
E
07GAF-SE00100
Press
(cont'd)
18-13