Automatic Transmission
ATF Replacement
NOTE: Keep all foreign particles out of the transmission.
1. Bring the transmission up to operating temperature
(the radiator fan comes on) by driving the vehicle.
2. Park the vehicle on the level ground, and turn the
engine off.
3. Remove the ATF filler bolt and the drain plug (A),
and drain the automatic transmission fluid (ATF).
NOTE: If a cooler flusher is used, refer to ATF
Cooler Flushing (see page 14-388).
A
18 x 1.5 mm
49 N·m (5.0 kgf·m,
36 lbf·ft)
B
4. Reinstall the drain plug with a new sealing washer
(B).
14-368
5. Refill the transmission with the recommended fluid
into the filler hole (A) to the upper mark on the
dipstick. Always use Honda ATF-Z1 Automatic
Transmission Fluid (ATF). Using a non-Honda ATF
can affect shift quality.
Automatic Transmission Fluid Capacity:
3.3 (3.5 US qt) at changing
7.9 (8.3 US qt) at overhaul
B
24 x 1.5 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
6. Install the ATF filler bolt (B) with a new sealing
washer (C).
C
A