Honda 2004 Odyssey Service Manual page 1111

Driveline/Axle
Driveshaft Reassembly (cont'd)
4. Insert the driveshaft (A) into the outboard joint (B)
until the circlip (C) is closed.
A
5. To completely seat the outboard joint, pick up the
driveshaft and joint, and tap it onto a hard surface
from 10 cm (4 in.). Do not use a hammer as
excessive force may damage the driveshaft. Be
careful not to damage the threaded section (A) of
the outboard joint.
A
10 cm
(4 in.)
16-14
B
C
Push.
Push.
6. Check the alignment of the paint mark (A) with the
outboard joint end (B).
A
7. Pack the outboard joint (A) with the joint grease
included in the new joint boot set.
Grease quantity
Outboard Joint: 110 130 g (3.9 4.6 oz)
Use the grease included
in the outboard boot set.
B
A