Shift Lock Solenoid Replacement - Honda 2004 Odyssey Service Manual

A/T Interlock System

Shift Lock Solenoid Replacement

SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Remove the steering column covers (see page 17-
25).
2. Shift the transmission into the N position.
3. Remove the nut (A) securing the shift cable end (B),
then separate the shift cable (C) from the shift lever
assembly (D).
D
A
8 x 1.25 mm
B
22 N·m (2.2 kgf·m, 16 lbf·ft)
4. Disconnect the shift lock solenoid connector (A)
and the park pin switch connector (B).
B
A
5. Remove the three bolts (C) securing the shift lever
assembly, then remove the shift lever assembly (D).
14-186
C
D
C
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
6. Remove the screws (A) securing the shift lock
solenoid (B), then remove the shift lock solenoid.
D
B
A
3 N·m
(0.3 kgf·m,
2 lbf·ft)
7. Install the shift lock solenoid plunger (C) and
plunger spring (D) in the new shift lock solenoid.
8. Install the shift lock solenoid by aligning the joint of
the shift lock solenoid with the tip of the shift lock
extension (E), then tighten the screws.
9. Install the shift lever assembly.
10. Install the shift cable end to the shift cable. If
necessary, adjust the shift cable (see page 14-162).
C
E