Honda 2004 Odyssey Service Manual page 802

Special Tools Required
Mainshaft holder
07GAB-PF50101 or 07GAB-PF50100
NOTE: Refer to the Exploded View as needed during the
following procedure.
1. Remove the transmission range switch cover.
2. Remove the harness clamp bolt and the two
transmission range switch bolts, then remove the
transmission range switch.
3. Remove the 16 bolts securing the end cover, then
remove the end cover.
4. Remove the pitot pipe (A) and the lubrication pitot
pipe (B) from the transmission housing (C), then
remove the pitot flange (D) from the mainshaft idler
gear (E).
D
E
B
A
C
5. Slip the special tool onto the mainshaft.
07GAB-PF50101 or
07GAB-PF50100
6. Engage the park pawl with the park gear.
7. Cut the lock tabs (A) of each shaft locknut (B) using
a chisel (C). Then remove the locknuts and conical
spring washers from each shaft.
NOTE:
• Countershaft and secondary shaft locknuts have
left-hand threads.
• Clean the old locknuts; they are used to install the
press fit idler gears on the mainshaft and
secondary shaft, and the park gear and bearing
hub on the countershaft.
• Keep all of the chiseled particles out of the
transmission.
B
8. Remove the special tool from the mainshaft.
C
A
(cont'd)
14-189