Honda 2004 Odyssey Service Manual page 1382

3. Install the latch in the reverse order of removal, and
note these items:
• Make sure the door locks and opens properly.
• If necessary, move the adjusting plate (A) to
adjust the door latch cable (B) and the auto-close
cable (C).
• Apply liquid thread lock to the adjusting plate
mounting bolt (D) before reinstallation.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perimeter.
B
Power sliding door
D
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 ·ft)
4. For EX and EX-L models: Re-home the power
sliding doors (see page 22-291).
Sliding Door Lower Roller Lever
Replacement
Power Sliding Door
1. For EX and EX-L models: Disable the power sliding
doors by turning off the main switch.
2. Remove the nuts, then loosen the cable adjusting
nuts (A) and disconnect the lower roller lever cable
(B) from the lower roller lever (C). Take care not to
bend the cable.
D
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
A
A
3. Install the lower roller lever in the reverse order of
removal, and note these items:
C
Fastener Locations
: Nut, 2
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
D
C A
• Make sure the lower roller cable is connected
properly.
• With the door fully open, make sure the power
sliding door handle switch (D) makes a clicking
sound as soon as the inner or outer door handle
is pulled. If necessary, adjust the cable adjusting
nuts.
• Check the sliding door operation. Make sure the
sliding door operates properly when the outside
handle is pulled (sliding door in the open
position; the sliding door closes fully).
B
20-17 20-17