Honda 2004 Odyssey Service Manual page 1265

ABS Components
DTC Troubleshooting (cont'd)
16. Connect the modulator unit connector.
17. Check for continuity between the appropriate ABS
control unit connector B (12P) terminal and all other
solenoid circuit terminals (see table).
DTC
31: FR-IN
32: FR-OUT
33: FL-IN
34: FL-OUT
35: RR-IN
36: RR-OUT
37: RL-IN
38: RL-OUT
ABS CONTROL UNIT CONNECTOR B (12P)
Wire side of female terminals
Is there less than 3
YES Replace the modulator unit.
NO Check for loose ABS control unit connectors.
If necessary, substitute a known-good ABS control
unit, and recheck.
19-64 19-64
Appropriate Terminal
No. 11
No. 6
No. 9
No. 4
No. 8
No. 3
No. 10
No. 5
?
DTC 41, 42, 43, 44: Wheel Lock
1. Test-drive the vehicle, and apply the brakes several
times to raise the brake temperature.
2. Raise the vehicle on a hoist, and check for
excessive brake drag.
Is there excessive brake drag?
YES Repair the cause of brake drag.
NO Go to step 3.
3. Check the installation of the appropriate wheel
sensor (see table).
DTC
41
42
43
44
Is it installed correctly?
YES The probable cause was the vehicle spun
during cornering. If the problem recurs, check the
modulator unit using the HDS.
NO Reinstall the wheel sensor correctly.
Appropriate Wheel Sensor
Right-front
Left-front
Right-rear
Left-rear