Honda 2004 Odyssey Service Manual page 842

NOTE: Refer to the Exploded View as needed during the
following procedure.
1. Install the differential assembly, countershaft
subassembly, mainshaft subassembly, and
secondary shaft subassembly in the torque
converter housing.
2. Install the countershaft 4th gear and reverse
selector hub on the countershaft. If the reverse
selector hub is a press-fitted type, refer to the
reverse selector hub installation procedures (see
page 14-211).
3. Turn the shift fork shaft (A) so the large chamfered
hole is facing the fork bolt hole. Then install the
shift fork (B) and reverse selector (C) together on
the shift fork shaft and countershaft (D). Secure the
shift fork to the shift fork shaft with the lock bolt (E)
and a new lock washer (F), then bend the lock
washer against the bolt head.
E
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
A
4. Install the needle bearing, countershaft reverse
gear, and countershaft 2nd gear on the
countershaft.
F
B
C
D
5. Place the thrust washer (A) in the transmission
housing.
6. Place the reverse idler gear (A) in the transmission
housing as shown, then slide it in the direction
shown.
A
A
(cont'd)
14-229