Honda 2004 Odyssey Service Manual page 1140

28. Coat the new 51 mm O-ring (A) with power steering
fluid, and position it in the bottom of the pump
housing (B).
C
A
B
29. Install the pump cover assembly (C) in the pump
housing.
30. Coat the flow control valve (A) with power steering
fluid, then install it and the spring (B) in the pump
housing.
A
B
C
D
49 N·m
(5.0 kgf·m, 36 lbf·ft)
31. Coat the new 16.7 mm O-ring (C) with power
steering fluid, and install it on the flow control
valve cap (D), then install the cap on the pump
housing, and tighten it.
8 x 1.25 mm
20 N·m
(2.0 kgf·m, 14 lbf·ft)
32. Coat the new 13 mm O-ring (A) with power steering
fluid, and install it on the inlet joint (B). Install the
inlet joint on the pump housing, and tighten the
flange bolt.
B
33. Install the pulley (A), then loosely install the pulley
nut (B). Hold the steering pump in a vise with soft
jaws. Be careful not to damage the pump housing
with the jaws of the vise.
07725-0030000
34. Hold the pulley with the special tool, and tighten
the pulley nut.
35. Check that the pump turns smoothly by turning the
pulley by hand. If it turns hard, loosen the four
flange bolts on the cover, then retighten them in
the same manner as in step 28. Turn the pump
again by hand.
A
11 N·m
(1.1 kgf·m, 8 lbf·ft)
B
64 N·m
(6.5 kgf·m, 47 lbf·ft)
A
17-21