Table of Contents
Advertisement
Shift Solenoid Valve B and C Test
1. Remove the starter.
2. Disconnect the shift solenoid valve B (A) or C (B)
connector.
A
B
3. Measure the resistance between the No. 1 and
No. 2 terminals of the shift solenoid valve B or C.
Standard:
12 25
4. Replace the shift solenoid valve B or C if the
resistance is out of standard.
5. If the resistance is within the standard, connect the
No. 2 terminal of the shift solenoid valve B or C
connector to the battery positive terminal, and
connect the No. 1 terminal to the battery negative
terminal. A clicking sound should be heard.
Replace the shift solenoid valve B or C if no clicking
sound is heard.
Shift Solenoid Valve B and C
Replacement
NOTE: If the shift solenoid valve B and C are replaced or
removed at the same time, be sure to reinstall them
correctly. The connector color of shift solenoid valve B
is black, and the connector color of shift solenoid valve
C is brown.
1. Remove the starter.
NOTE: If you are only replacing shift solenoid valve
C, starter removal is not needed.
2. Remove the mounting bolt and the shift solenoid
valve B.
C
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
3. Remove the mounting bolt and the shift solenoid
valve C.
4. Install a new shift solenoid valve B (A) or C (B) with
new O-rings (C). While installing the valves, do not
allow dust or other foreign particles to enter the
transmission.
5. Check the connector for rust, dirt or oil, then
reconnect it.
6. Install the starter, if removed.
C
B
14-131
14-131
Advertisement
Chapters
Table of Contents
Troubleshooting
