Sliding Door Position Adjustment - Honda 2004 Odyssey Service Manual

Doors

Sliding Door Position Adjustment

NOTE: For EX models, be sure to disable the power
sliding door by turning the main switch off.
1. Loosen the bolts (A) on the door's female stops (B)
enough to move the stops.
B
2. Turn the door cushion (A) clockwise as far as it will
go.
20-28
3. Mark the position of the center roller (A) with a
permanent marker. This will help you gauge the
amount of adjustment needed for the roller.
Mark the position here.
A
A
4. Close the sliding door fully, then inspect the gaps at
the front and rear of the door. Also inspect the top
to bottom position of the rear of the door, using the
center body line as a reference.
NOTE: For best junction switch contact, make the
gap at the front of the door smaller than the rear
gap. But don't make the front gap smaller than
4.5 mm (0.18 in.) or the rear gap larger then 8.5 mm
(0.33 in.).
A
REAR GAP 8.5 mm (0.33 in.) or
SMALLER
FRONT GAP 4.5 mm (0.18 in.) or
LARGER