Honda 2004 Odyssey Service Manual page 999

Automatic Transmission
Transmission Installation (cont'd)
44. Install the starter (A) on the torque converter
housing. Connect the starter cables (B) to the
starter, and install the harness clamp (C) on the
clamp bracket (D). Make sure the crimped side of
the starter cable ring terminal is facing out.
9 N·m
(0.9 kgf·m, 6.5 lbf·ft)
B
C
14-386
A
12 x 1.25 mm
D
64 N·m
(6.5 kgf·m, 47 lbf·ft)
45. Connect the ATF cooler hoses (A) to the ATF cooler
lines (B) (see page 14-389). Clamp the ATF cooler
hose with the clamp (C) on the starter by aligning
the white dot (D) on the hose with the clamp.
C
D
A
B
46. Install the transmission breather tube (A) in the
clamp (B) by aligning the dot (C) with the clamp.
47. Install the battery base bracket and battery base.
48. Install the battery cable clamps, connector, and
relay bracket on the battery base.
49. Install the battery tray and battery, then secure the
battery with its hold-down bracket.
50. Install the intake air duct, resonator cover, and air
cleaner housing assembly.
B
A
A
C
B