Honda 2004 Odyssey Service Manual page 1262

DTC 31, 32, 33, 34, 35, 36, 37, 38:
1. Verify the DTC.
Is DT C 54 indicated?
YES Do the appropriate troubleshooting for DTC
54.
NO Go to step 2.
2. Turn the ignition switch OFF.
3. Disconnect the modulator unit connector and the
ABS control unit connector B (12P).
4. Check for continuity between the appropriate ABS
control unit connector B (12P) solenoid circuit
terminal and body ground (see table).
DTC
31: FR-IN
32: FR-OUT
33: FL-IN
34: FL-OUT
35: RR-IN
36: RR-OUT
37: RL-IN
38: RL-OUT
ABS CONTROL UNIT CONNECTOR B (12P)
FL-OUT (YEL/BLU)
RR-OUT
(YEL/WHT)
RR-IN (RED/WHT)
FL-IN (RED/BLU)
Wire side of female terminals
Is there continuity?
YES Repair short to body ground in the
appropriate solenoid circuit wire between the ABS
control and the modulator unit.
NO Go to step 5.
Solenoid
Appropriate Terminal
No. 11
No. 6
No. 9
No. 4
No. 8
No. 3
No. 10
No. 5
RL-OUT (YEL/GRN)
FR-OUT
(YEL/BLK)
FR-IN (RED/BLK)
RL-IN (RED/GRN)
5. Connect the modulator unit connector.
6. Check for continuity between the appropriate ABS
control unit connector B (12P) solenoid circuit
terminal and body ground (see table).
DTC
31: FR-IN
32: FR-OUT
33: FL-IN
34: FL-OUT
35: RR-IN
36: RR-OUT
37: RL-IN
38: RL-OUT
ABS CONTROL UNIT CONNECTOR B (12P)
FL-OUT (YEL/BLU)
RR-OUT
(YEL/WHT)
RR-IN (RED/WHT)
FL-IN (RED/BLU)
Wire side of female terminals
Is there continuity?
YES Replace the modulator unit.
NO Go to step 7.
7. Disconnect the modulator unit connector.
Appropriate Terminal
No. 11
No. 6
No. 9
No. 4
No. 8
No. 3
No. 10
No. 5
RL-OUT (YEL/GRN)
FR-OUT
(YEL/BLK)
FR-IN (RED/BLK)
RL-IN (RED/GRN)
(cont'd)
19-61