A/T Differential
Carrier Bearing Outer Race Replacement
Special Tools Required
• Driver 07749-0010000
• Attachment, 78 x 80 mm 07NAD-PX40100
NOTE:
• Replace the bearing with a new one whenever the
outer race is replaced.
• Do not use shim(s) on the torque converter housing
side.
• Adjust preload after replacing the bearing and outer
race.
• Coat all parts with ATF during installation.
1. Remove the bearing outer race from the
transmission housing by heating the housing to
about 212°F (100°C) with a heat gun. Do not heat
the housing to more than 212°F (100°C).
2. Remove the bearing outer race from the torque
converter housing.
3. Install the thrust shim (A), thrust washer (B), and
outer race (C) in the transmission housing (D) with
the special tools.
D
14-480
C
B
A
07749-0010000
07NAD-PX40100
4. Install the thrust washer (A) and outer race (B) in
the torque converter housing (C), and use the
special tools to make sure the outer race bottoms
out in the housing.
B
A
07NAD-PX40100
C
07749-0010000