39. Install the harness cover (A) on the transmission
hanger (B), then install the connector bracket (C).
8 x 1.25 mm
26 N·m (2.7 kgf·m,
20 lbf·ft)
A
B
40. Install the torque converter clutch solenoid valve/
shift solenoid valve A connector (D) on the harness
cover, then connect the connector.
41. Connect the connectors to the 3rd clutch pressure
switch (A), mainshaft speed sensor (B), and A/T
clutch pressure control solenoid valves A and B (C),
then install the clamps on the clamp brackets. Do
not allow fluid, oil, dust, or other foreign particles
to enter the connectors.
C
8 x 1.25 mm
26 N·m (2.7 kgf·m,
20 lbf·ft)
D
C
B
A
42. Connect the connectors to the shift solenoid valve
B (A) and shift solenoid valve C (B), then install the
clamp on the clamp bracket.
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)
D
A
B
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
C
7.2 lbf·ft)
43. Install the transmission ground cable terminal (C).
44. Install the starter (D) on the torque converter
housing. Connect the starter cables (E) to the
starter, and install the harness clamp on the clamp
bracket. Make sure the crimped side of the starter
cable ring terminal is facing out.
E
E
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
47 lbf·ft)
9 N·m (0.9 kgf·m,
6.5 lbf·ft)
(cont'd)
14-153