Honda 2004 Odyssey Service Manual page 1396

14. Loosen the three bolts on the lower roller (A). Move
the door up or down to align the body lines and to
provide good junction switch contact. Loosen the
lower roller bottom nut to adjust the door in or out
until the door is held tightly against the seals.
When you're finished with this adjustment, torque
the three top bolts, and torque the bottom nut.
NOTE: For best junction switch contact, make sure
there is minimal in and out movement at the front
of the door while keeping the door flush to the body.
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
15. Remove the weatherstrip (A) from the rear edge of
the door opening.
A
16. Turn on the power sliding door main switch.
17. Hold a piece of paper over the door cushion, then
close the door with the paper trapped between the
cushion and the door. Make sure not to pinch the
weatherstrip.
18. Pull out the paper.
• If the paper is held tight, but you can pull it out
without ripping it, go to step 19.
• If the paper rips or is not held tight, adjust the
door cushion until the paper is held tight but you
can pull it out without ripping it.
A
Then go to step 19.
19. Tighten the bolts on the female stops (A) to the
6 x 1.0 mm
9.8 N·m
point where the stops can move but will still hold
(1.0 kgf·m,
their position.
7.2 lbf·ft)
20. Close the sliding door, then open it.
21. Carefully tighten the stop bolts, alternating
between the top and the bottom bolt, until all four
bolts are torqued.
NOTE: The stop will pivot if you apply too much
torque to one bolt while the other is loose.
A
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
20-31