Honda 2004 Odyssey Service Manual page 847

Transmission End Cover
End Cover and Idler Gear Installation (cont'd)
18. Lubricate the threads of each shaft, the new
locknuts, and the new conical spring washers with
ATF.
19. Install the new conical spring washers (A) in the
direction shown, and install the new locknuts (B).
B
A
20. Tighten the locknut to 167 N·m, (17.0 kgf·m, 123
lbf·ft).
NOTE:
• Use a torque wrench to tighten the locknut. Do
not use an impact wrench.
• Countershaft and secondary shaft locknuts have
left-hand threads.
21. Stake each locknut into its shaft using a 3.5 mm
punch.
14-234
B
A
B
A
22. Install the pitot flange (A) on the mainshaft idler
gear (B), then install the lubrication pitot pipe (C)
and the pitot pipe (D) on the transmission housing.
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
A
B
23. Set the park lever in P position, then verify that the
park pawl (A) engages the park gear (B).
B
A
D
E
F
24. If the park pawl does not engage fully, check the
distance between the pawl shaft (C) and the park
lever roller pin (D) (see page 14-190).
25. Tighten the lock bolt (E), and bend the lock tab of
the lock washer (F) against the lock bolt head.
D C
C