D-Link xStack DGS-3420 Series Reference Manual page 616

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
53-2 config loopback ipif
Description
This command is used to configure the loopback interface parameters.
Format
config loopback ipif <ipif_name 12> [{ipaddress <network_address> | state [enable |
disable]}(1)]
Parameters
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can be
up to 12 characters long.
ipaddress – (Optional) Specifies the IPv4 network address of the loopback interface.
<network_address> - Enter the IPv4 network address of the loopback interface here. It specifies
a host address and length of network mask.
state - (Optional) Specifies the state of the loopback interface.
enable - Specifies that the loopback interface state will be enabled.
disable - Specifies that the loopback interface state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the loopback interface named loopback1 with subnet address 10.0.0.1/8:
DGS-3420-28SC:admin# config loopback ipif loopback1 ipaddress 10.0.0.1/8
Command: config loopback ipif loopback1 ipaddress 10.0.0.1/8
Success.
DGS-3420-28SC:admin#
53-3 show loopback ipif
Description
This command is used to display the information of the loopback interface.
Format
show loopback ipif {<ipif_name 12>}
611