D-Link xStack DGS-3420 Series Reference Manual page 783

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
and 5.
pdelay_req_interval - (Optional) Specifies the permitted mean time interval between successive
pdelay_request messages.
<sec 1-32> - Enter the permitted mean time interval value used here. This value must be
between 1 and 32 seconds.
delay_mechanism - (Optional) Specifies the mechanism for measuring the propagation delay
time of an event message.
e2e - E2E indicates that the port is configured to use the delay request-response mechanism.
p2p - P2P indicates that the port is configured to use the peer delay mechanism.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the announce interval attribute of ports 1-4 to 3 seconds:
DGS-3420-28SC:admin# config ptp boundary ports 1:1-1:4 announce interval 3
Command: config ptp boundary ports 1:1-1:4 announce interval 3
The announce interval is automatically adjusted to 4.
Success.
DGS-3420-28SC:admin#
To configure the announce timeout attribute of ports 1-4 to 4 seconds, which is about 4*Announce
interval:
DGS-3420-28SC:admin# config ptp boundary ports 1:1-1:4 announce timeout 4
Command: config ptp boundary ports 1:1-1:4 announce timeout 4
Success.
DGS-3420-28SC:admin#
To configure the sync_interval attribute of the all the PTP ports to 2 seconds:
DGS-3420-28SC:admin# config ptp boundary ports all sync_interval 2
Command: config ptp boundary ports all sync_interval 2
Success.
DGS-3420-28SC:admin#
If the sync_interval is 0.5 seconds, then the delay_req_interval attribute of the all PTP ports is
configured as 0.
778