D-Link xStack DGS-3420 Series Reference Manual page 406

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
ring_mel - Specify the ring MEL of the R-APS function. The default ring MEL is 1.
<value 0-7> - Specify a value between 0 and 7.
ring_port - Specify a port participating in the ERPS ring.
west - Specify the port as the west ring port.
<port> - Specify a port.
virtual_channel - Specify the port as a west port on the virtual channel.
east - Specify the port as the east ring port.
<port> - Specify a port.
virtual_channel - Specify the port as an east port on the virtual channel.
rpl_port - By default, the node has no RPL port.
west - Specify the west ring port as the RPL port.
east - Specify the east ring port as the RPL port.
none - No RPL port on this node.
rpl_owner - By default, the RPS owner is disabled.
enable - Specify the device as an RPL owner node.
disable - This node is not an RPL owner.
protected_vlan - Specify VLANs that are protected by the ERPS function. The R-APS VLAN cannot
be the protected VLAN. The protected VLAN can be one that has already been created, or it can
be used for a VLAN that has not yet been created.
add - Add VLANs to the protected VLAN group
delete - Delete VLANs from the protected VLAN group.
vlanid - Specify a VLAN ID list.
<vidlist> - Specify a range of VLAN IDs.
sub_ring - Specifies the sub-ring configuration information.
raps_vlan - Specify the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
tc_propagation - Specifies to configure the state of the topology change propagation for the sub-
ring.
state - Specifies the propagation state of the topology change for the sub-ring.
enable - Enable the propagation state of the topology change for the sub-ring.
disable - Disable the propagation state of the topology change for the sub-ring.
add - Specifies the add a topology change propagation rule.
delete - Specifies the delete a topology change propagation rule.
sub_ring - Specifies the sub-ring configuration.
raps_vlan - Specify the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
revertive - Specifies the revertive mode state.
enable - Specifies that the revertive mode will be enabled..
disable - Specifies that the revertive mode will be disabled.
timer - Configure the ERPS timers for a specific R-APS VLAN.
holdoff_time - Specify the holdoff time of the R-APS function.
<value 0-10000> - Specify the time between 0 and 10000. The default hold off time is 0
milliseconds.
guard_time - Specify the guard time of the R-APS function.
<value 10-2000> - Specify the time between 10 and 2000. The default guard time is 500
milliseconds.
wtr_time - Specify the WTR time of the R-APS function.
<value 5-12> - Specify the time between 5 and 12. The default WTR time is 5 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
401