D-Link xStack DGS-3420 Series Reference Manual page 936

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
19-2 config stacking force_master_role state
Description
This command is used to configure stacking force master role state. If state is enabled, when device is
in election state, it still uses old priority setting and MAC to compare device priority. After stacking is
stable, master's priority will become zero. If stacking topology change again, Master will use priority
zero and MAC address to determine who new primary master is.
Format
config stacking force_master_role state [enable | disable]
Parameters
enable - Specifies that the Switch's Stacking Force Master Role state will be enabled.
disable - Specifies that the Switch's Stacking Force Master Role state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable stacking force master role state:
DGS-3420-28SC:admin# config stacking force_master_role state enable
Command: config stacking force_master_role state enable
Success.
DGS-3420-28SC:admin#
19-3 show stacking_mode
Description
This command displays the current stacking mode.
Format
show stacking_mode
Parameters
None.
931