D-Link xStack DGS-3420 Series Reference Manual page 1009

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
show broadcast_ping_reply
Parameters
None.
Restrictions
None.
Example
To show broadcast ping reply state:
DGS-3420-28SC:admin# show broadcast_ping_reply
Command: show broadcast_ping_reply
Broadcast Ping Reply State:
DGS-3420-28SC:admin#
29-26 config tftp source_ipif
Description
This command is used to select an address of an interface as the source address for TFTP.
Format
config tftp source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters long.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to remove the specified source address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IP 10.90.90.90 on System interface as the source address:
DGS-3420-28SC:admin#config tftp source_ipif System 10.90.90.90
Enabled
1004