D-Link xStack DGS-3420 Series Reference Manual page 841

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the RIPng method as poison reverse:
DGS-3420-28SC:admin# config ripng method poison_reverse
Command: config ripng method poison_reverse
Success.
DGS-3420-28SC:admin#
8-5 config ripng ipif
Description
This command is used to specify the RIPng state and metric value for one or all interfaces
Format
config ripng ipif [<ipif_name 12> | all] {state [enable | disable] | metric <value 1-15>}(1)
Parameters
ipif - (Optional) Specifies the RIPng IP interface name to be configured.
<ipif_name 12> - Enter the RIPng IP interface name to be configured here. This name can be
up to 12 characters long.
all - Specifies that all the RIPng IP interfaces will be used.
state - (Optional) Specifies the RIPng state of the specified IP interface.
enable - Specifies that the RIPng state on the specified interface will be enabled.
disable - Specifies that the RIPng state on the specified interface will be disabled.
metric - (Optional) Specifies the cost value of an interface. The RIPng route that was learned
from the interface will add this value as a new route metric.
<value 1-15> - Enter the metric value used here. This value must be between 1 and 15. The
default value is 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the RIPng interface state:
DGS-3420-28SC:admin# config ripng ipif System state enable
Command: config ripng ipif System state enable
Success.
DGS-3420-28SC:admin#
836