D-Link xStack DGS-3420 Series Reference Manual page 465

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
all - Specifies that all VLANs will be configured.
vlan_name - Specifies the VLAN name used.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters
long.
vlanid - Specifies the VLAN ID used.
<vlanid_list> - Enter the VLAN ID used here.
state - (Optional) Specifies to enable or disable the data driven learning of an IGMP snooping
group. By default, the state is enabled.
enable - Specifies that the data driven learning of an IGMP snooping group will be enabled.
disable - Specifies that the data driven learning of an IGMP snooping group will be disabled.
aged_out - (Optional) Specifies that the aging out of the entry will be enabled or disabled.
enable - Specifies that the aging out of the entry will be enabled.
disable - Specifies that the aging out of the entry will be disabled.
expiry_time - (Optional) Specifies the data driven group lifetime value used. This value is only
applicable if the aged out option is enabled.
<sec 1-65535> - Enter the expiry time value used here. This value must be between 1 and
65535 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the data driven learning of an IGMP snooping group on the default VLAN:
DGS-3420-28SC:admin#config igmp_snooping data_driven_learning vlan_name default
state enable
Command: config igmp_snooping data_driven_learning vlan_name default state
enable
Success.
DGS-3420-28SC:admin#
39-21 config igmp_snooping data_driven_learning max_learned_entry
Description
This command is used to configure the maximum number of groups that can be learned by data driven.
When the table is full, the system will stop the learning of the new data-driven groups. Traffic for the
new groups will be dropped.
Format
config igmp_snooping data_driven_learning max_learned_entry <value 1-960>
460