D-Link xStack DGS-3420 Series Reference Manual page 1056

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the WAC default redirect path:
DGS-3420-28SC:admin#config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
DGS-3420-28SC:admin#
34-7 config wac clear_default_redirpath
Description
This command is used to clear the WAC default redirect path. When the string is cleared, the client will
not be redirected to another URL after successful authentication.
Format
config wac clear_default_redirpath
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear the WAC default redirect path:
DGS-3420-28SC:admin#config wac clear_default_redirpath
Success.
DGS-3420-28SC:admin#
34-8 config wac virtual_ip
Description
This command is used to configure the WAC virtual IP address. When virtual IP is specified, the TCP
packets sent to the virtual IP will get a reply. If virtual IP is enabled, TCP packets sent to the virtual IP
or physical IPIF's IP address will both get the reply. When virtual IP is set 0.0.0.0, the virtual IP will be
disabled. By default, the virtual IP is 0.0.0.0. The virtual IP will not respond to any ARP requests or
ICMP packets. To make this function work properly, the virtual IP should not be an existing IP address.
It also cannot be located on an existing subnet.
1051