D-Link xStack DGS-3420 Series Reference Manual page 268
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
debug dhcpv6_server state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 server debug function:
DGS-3420-28SC:admin# debug dhcpv6_server state enable
Command: debug dhcpv6_server state enable
Success.
DGS-3420-28SC:admin#
19-27 debug ripng flag
Description
This command is used to enable or disable the RIPng debug flag.
Format
debug ripng flag [{interface | packet [all | rx | tx] | route} | all] state [enable | disable]
Parameters
interface - (Optional) Specifies the state of the RIPng interface debug. The default setting is
disabled.
packet - (Optional) Specifies which packets should be set with debug flags.
all - Specifies to set all packets with debug flags.
rx - Specifies to set inbound packets with debug flag.
tx - Specifies to set outbound packets with debug flag.
route - (Optional) Specifies the state of the RIPng route debug. The default setting is disabled.
all - Specifies to set all debug flags.
state - Specifies the designated flags state.
enable - Specifies that the designated flags state will be enabled.
disable - Specifies that the designated flags state will be disabled.
263
Advertisement
Table of Contents
