D-Link xStack DGS-3420 Series Reference Manual page 1021

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
delete - Specify to delete a user-defined OUI of Voice device vendor.
<macaddr> - Specify a user-defined OUI MAC address.
<macmask> - Specify a user-defined OUI MAC address mask.
description - (Optional) Specify a description for the user-defined OUI.
<desc 32> - Specify a description for the user-defined OUI. The maximum length is 32
characters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a user-defined OUI of a voice device:
DGS-3420-28SC:admin#config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-00
Command: config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-00
Success.
DGS-3420-28SC:admin#
31-5 config voice_vlan ports
Description
This command is used to enable or disable the voice VLAN function on ports or mode per port.
Format
config voice_vlan ports [<portlist> | all] [state [enable | disable] | mode [auto | manual]]
Parameters
<portlist> - Specify a range of ports to set.
all - Specify to set all ports.
state - Specify the voice VLAN function state on ports. The default state is disabled.
enable - Specify to enable the voice VLAN function state on ports.
disable - Specify to disable the voice VLAN function state on ports.
mode - The voice VLAN mode. The default mode is auto.
auto - When the mode is auto, the port may become the voice VLAN member port by auto-
learning. If the MAC address of the received packet matches the configured OUI, the port will
be learned as dynamic member port. The dynamic membership will be removed via the aging
out mechanism.
manual - When the mode is set to manual, the port needs to be manually added into or removed
from the voice VLAN by 802.1Q VLAN configuration command.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
1016