Chapter 33 Vlan Trunking Commands - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 33
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist> | all] state [enable | disable]
show vlan_trunk
33-1
enable vlan_trunk
Description
This command is used to enable VLAN trunking. When VLAN trunking function is enabled, the VLAN
trunk ports shall be able to forward all tagged frames with any VID.
Format
enable vlan_trunk
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable VLAN trunking:
DGS-3420-28SC:admin#enable vlan_trunk
Command: enable vlan_trunk
Success
DGS-3420-28SC:admin#
33-2
disable vlan_trunk
Description
This command is used to disable VLAN trunking.
VLAN Trunking
Commands
1041
Advertisement
Table of Contents
