D-Link xStack DGS-3420 Series Reference Manual page 671

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
disable - Disable data driven learning of an MLD snooping group.
aged_out - Enable or disable the aging of the entry. This is disabled by default.
enable - Enable the aging of the entry.
disable - Disable the aging of the entry.
expiry_time - Specify the data driven group lifetime in seconds. This parameter is valid only
when aged_out is enabled.
<sec 1-65535> - Specify the time between 1 and 65535 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the data driven learning of an MLD snooping group on default VLAN:
DGS-3420-28SC:admin#config mld_snooping data_driven_learning vlan_name default
state enable
Command: config mld_snooping data_driven_learning vlan_name default state
enable
Success.
DGS-3420-28SC:admin#
58-21 config mld_snooping data_driven_learning max_learned_entry
Description
This command is used to configure the maximum number of groups that can be learned by data driven.
When the table is full, the system will stop learning of the new data-driven groups. Traffic for the new
groups will be dropped.
Format
config mld_snooping data_driven_learning max_learned_entry <value 1-480>
Parameters
<value 1-480> - Specify the maximum number of groups that can be learned by data driven. The
default setting is 120.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the maximum number of MLD snooping data driven learning entries as 50:
666