D-Link xStack DGS-3420 Series Reference Manual page 218

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To display CFM remote MEP information:
DGS-3420-28SC:admin#show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID
MAC Address
Status
RDI
Port State
Interface Name
Last CCM Serial Number
Send Chassis ID
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time
DGS-3420-28SC:admin#
14-28 config cfm ais md
Description
This command is used to configure the parameters of the AIS function on an MEP.
Format
config cfm ais md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> | ma_index
<uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> | state [enable |
disable]}
Parameters
md - Specify the maintenance domain name.
<string 22> - Specify the maintenance domain name. The maximum length is 22 characters.
md_index - Specify the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - Specify the maintenance association name.
<string 22> - Specify the maintenance association name. The maximum length is 22
characters.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
mepid - Specify the MEPID.
<int 1-8191> - Specify the MEP MEPID between 1 and 8191.
period - (Optional) Specifies the transmitting interval of the AIS PDU.
: 2
: 00-11-22-33-44-02
: OK
: Yes
: Blocked
: Down
: 1000
: 00-11-22-33-44-00
: 2008-01-01
213