D-Link xStack DGS-3420 Series Reference Manual page 678

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
59-6 show mld_snooping multicast_vlan_group_profile
Description
This command is used to display an MLD snooping multicast group profile.
Format
show mld_snooping multicast_vlan_group_profile {<profile_name 1-32>}
Parameters
<profile_name 1-32> - (Optional) Specify the multicast VLAN profile name. The maximum length is
32 characters.
Restrictions
None.
Example
To display all MLD snooping multicast VLAN profiles:
DGS-3420-28SC:admin#show mld_snooping multicast_vlan_group_profile
Command: show mld_snooping multicast_vlan_group_profile
Profile Name
-----------------------
rock
Total Entries : 1
DGS-3420-28SC:admin#
59-7 config mld_snooping multicast_vlan_group
Description
This command is used to configure the multicast group which will be learned with the specific multicast
VLAN. There are two cases that need to be considered. For the first case, suppose that a multicast
group is not configured and multicast VLANs do not have overlapped member ports. That means the
join packets received by the member port will only be learned with the multicast VLAN that this port
belongs to. If not, which is the second case, the join packet will be learned with the multicast VLAN
that contains the destination multicast group. If the destination multicast group of the join packet can
not be classified into any multicast VLAN that this port belongs to, then the join packet will be learned
with the natural VLAN of the packet. Please note that the same profile can not overlap different
multicast VLANs. Multiple profiles can be added to a multicast VLAN, however.
Multicast Addresses
--------------------------------
FF1E::1
FF1E::10-FF1E::20
673