D-Link xStack DGS-3420 Series Reference Manual page 639

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
55-19 config mac_based_access_control trap state
Description
This command is used to enable or disable the sending of MAC-based Access Control traps.
Format
config mac_based_access_control trap state [enable | disable]
Parameters
state - Specifies the trap state for MAC-based Access Control.
enable - Specifies that the trap state for MAC-based Access Control will be enabled.
disable - Specifies that the trap state for MAC-based Access Control will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the trap state for MAC-based Access Control:
DGS-3420-28SC:admin# config mac_based_access_control trap state enable
Command: config mac_based_access_control trap state enable
Success.
DGS-3420-28SC:admin#
55-20 config mac_based_access_control password_type
Description
This command is used to configure the type of RADIUS authentication password for MAC-based
Access Control.
Format
config mac_based_access_control password_type [manual_string | client_mac_address]
Parameters
manual_string - Specifies to use the same string as password for all clients do RADIUS
authentication, the string can be configured by using the command "config
mac_based_access_control password".
client_mac_address - Specifies to use the client's MAC address as the password for RADIUS
authentication. The MAC address format can be configured by using the command "config
634