D-Link xStack DGS-3420 Series Reference Manual page 134

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
disable cpu_interface_filtering
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable CPU interface filtering:
DGS-3420-28SC:admin#disable cpu_interface_filtering
Command: disable cpu_interface_filtering
Success.
DGS-3420-28SC:admin#
5-14 config flow_meter
Description
This command is used to configure the flow-based metering function. The metering function supports
three modes: single rate two color, single rate three color, and two rate three color. The access rule
must be created before the parameters of this function can be applied. For the single rate two color
mode, users may set the preferred bandwidth for this rule, in Kbps, and once the bandwidth has been
exceeded, overflowing packets will either be dropped or remarked DSCP, depending on the user
configuration. For single rate three color mode, users need to specify the committed rate, in Kbps, the
committed burst size, and the excess burst size. For the two rate three color mode, users need to
specify the committed rate in Kbps, the committed burst size, the peak rate and the peak burst size.
The green color packet will be treated as the conforming action, the yellow color packet will be treated
as the exceeding action, and the red color packet will be treated as the violating action.
The replace DSCP action can be performed on packets that conform (GREEN) and packets that do
not conform (YELLOW and RED). If drop YELLOW/RED is selected, the action to replace the DSCP
will not take effect. The color mapping for both "single rate three color" and "two rate three color" mode
follow RFC 2697 and RFC 2698 in the color-blind situation.
Format
config flow_meter [profile_id <value 1-6> | profile_name <name 1-32>] access_id <value 1-256>
[rate [<value 0-1048576>] {burst_size [<value 0-131072>]} rate_exceed [drop_packet |
remark_dscp <value 0-63>] | tr_tcm cir <value 0-1048576> {cbs <value 0-131072>} pir <value 0-
1048576> {pbs <value 0-131072>} {[color_blind | color_aware]} {conform [permit | replace_dscp
129