D-Link xStack DGS-3420 Series Reference Manual page 675

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
source_port - Specify source port where the multicast traffic is entering the Switch.
<portlist> - Specify a range of ports to be configured.
untag_source_port - Specify the untagged source port where the multicast traffic is entering the
Switch. The PVID of the untagged source port is automatically changed to the multicast VLAN.
Source ports must be either tagged or untagged for any single multicast VLAN, i.e. both types
cannot be members of the same multicast VLAN
<portlist> - Specify a range of ports to be configured.
tag_member_port - Specify the tagged member port of the multicast VLAN.
<portlist> - Specify a range of ports to be configured.
state - Specify if the multicast VLAN for a chosen VLAN should be enabled or disabled.
enable - Enable multicast VLAN for the chosen VLAN.
disable - Disable multicast VLAN for the chosen VLAN.
replace_source_ipv6 - With the MLD snooping function, the MLD report packet sent by the host will
be forwarded to the source port. Before forwarding of the packet, the source IP address in the join
packet needs to be replaced by this IP address. If none is specified, the source IP address will
use :: ip address
<ipv6addr> - Enter the IP address here.
none - Specifies that the replace source IPv6 address will not be replaced.
remap_priority - Specify the remap priority here.
<value 0-7> - The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
none - If none is specified, the packet's original priority is used. The default setting is none.
replace_priority - (Optional) Specify that the packet priority will be changed to the remap priority,
when remap priority is set.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an MLD snooping multicast VLAN with the name "v1", make ports 1 and 3 members of
the VLAN, and set the state to enable:
DGS-3420-28SC:admin#config mld_snooping multicast_vlan v1 add member_port 1,3 state
enable
Command: config mld_snooping multicast_vlan v1 add member_port 1,3
state enable
Success.
DGS-3420-28SC:admin#
59-3 create mld_snooping multicast_vlan_group_profile
Description
This command is used to create a multicast group profile. The profile name for MLD snooping must be
unique.
670