D-Link xStack DGS-3420 Series Reference Manual page 655

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
None.
Example
To display the MLD snooping packet rate limit for ports 1 to 2:
DGS-3420-28SC:admin#show mld_snooping rate_limit ports 1-2
Command: show mld_snooping rate_limit ports 1-2
Port Rate Limit(pkt/sec)
-------- --------------------
1 No Limit
2 No Limit
Total Entries: 2
DGS-3420-28SC:admin#
58-4 create mld_snooping static_group
Description
This command is used to create an MLD snooping multicast static group. Member ports can be added
to the static group. The static member and the dynamic member port form the member ports of a
group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For those static
member ports, the device needs to emulate the MLD protocol operation to the querier, and forward the
traffic destined to the multicast group to the member ports. For a layer 3 device, the device is also
responsible to route the packet destined for this specific group to static member ports. The Reserved
IP multicast addresses FF0x::/16 must be excluded from the configured group. The VLAN must be
created first before a static group can be created.
Format
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
Parameters
vlan - Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
vlanid - Specify the VLAN ID list.
<vlanid_list> - Specify the VLAN ID list.
<ipv6addr> - Specify the multicast group IPv6 address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
650