D-Link xStack DGS-3420 Series Reference Manual page 272

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Prompt# debug show status module MSTP
Command: debug show status module MSTP
Debug Global State
MSTP
Prompt#
To show the debug state:
Prompt# debug show status
Command: debug show status
Debug Global State: Enable
SYS : Enable
OS : Enable
MSTP : Enable
ACL : Disable
CLI : Enable
SNMP : Disable
IGMP : Enable
Prompt#
19-32 debug show address_binding binding_state_table
Description
This command is used to display the binding state of the entries in the binding state table.
Format
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
Parameters
nd_snooping - Specifies to debug ND Snooping bound addresses in the binding state table.
dhcpv6_snooping - Specifies to debug DHCPv6 Snooping bound addresses in the binding state
table.
Restrictions
Only Administrator-level users can issue this command.
: Enable
: Enable
267