Chapter 26 Time And Sntp Commands - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 26
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>} (1)
config sntp ipv6server {primary <ipv6addr> | secondary <ipv6addr>}
show sntp
enable sntp
disable sntp
config time <date ddmthyyyy> <time hh:mm:ss>
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>} (3)
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4, last> | e_day <end_day
sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} (9) |
annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_date
<end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}(7)]
show time
26-1 config sntp
Description
This command is used to change SNTP configurations.
Format
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>} (1)
Parameters
primary - (Optional) Specify the SNTP primary server IP address.
<ipaddr> - Specify the SNTP primary server IP address.
secondary - (Optional) Specify the SNTP secondary server IP address.
<ipaddr> - Specify the SNTP secondary server IP address.
poll-interval - (Optional) Specify the polling interval range.
<int 30-99999> - Specify the polling interval range between 30 and 99999 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure SNTP:
Time and SNTP
Commands
963