D-Link xStack DGS-3420 Series Reference Manual page 698
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<ipaddr> - Specify the IP address of the trusted host.
<ipv6addr> - Specify the IPv6 address of the trusted host.
network - Specify the network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Specify the network address of the trusted network. The form of network
address is xxx.xxx.xxx.xxx/y.
ipv6_prefix - Specify the IPv6 network address of the trusted network.
<ipv6networkaddr> - Specify the IPv6 network address of the trusted network.
snmp - (Optional) Specify the trusted host for SNMP.
telnet - (Optional) Specify the trusted host for Telnet.
ssh - (Optional) Specify the trusted host for SSH.
http - (Optional) Specify the trusted host for HTTP.
https - (Optional) Specify the trusted host for HTTPs.
ping - (Optional) Specify the trusted host for Ping.
Note: If no management method is specified, the IP (range) can access the Switch through
any method.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a trusted host:
DGS-3420-28SC:admin#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3420-28SC:admin#
62-5
config trusted_host
Description
This command is used to configure the access interfaces for the trusted host.
Format
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
693
Advertisement
Table of Contents
