D-Link xStack DGS-3420 Series Reference Manual page 798

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3420-28SC:admin#
4-4 show dot1v_protocol_group
Description
This command is used to display the protocols defined in protocol groups.
Format
show dot1v_protocol_group {[group_id <int 1-16> | group_name <name 32>]}
Parameters
group_id - (Optional) Specify the group ID to be displayed.
<int 1-16> - Specify the group ID to be displayed.
group_name - (Optional) Specify the name of the protocol group.
<name 32> - Specify the name of the protocol group. The maximum length is 32 characters.
Note: If no parameter is specified, all configured protocol groups will be displayed
Restrictions
None.
Example
To display protocol group ID 4:
DGS-3420-28SC:admin# show dot1v_protocol_group group_id 4
Command: show dot1v_protocol_group group_id 4
Protocol Protocol
Group ID Group Name
--------- ---------------
4 General Group
Total Entries: 1
DGS-3420-28SC:admin#
4-5 config port dot1v ports
Description
This command is used to assign the VLAN for untagged packets ingress from the portlist based on the
protocol group configured. This assignment can be removed by using the delete protocol_group
option.
Frame Type
------------
EthernetII
793
Protocol
Value
------------
86dd