D-Link xStack DGS-3420 Series Reference Manual page 744

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
65-2 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover from
shutdown forever status. The time allowed for auto recovery from shutdown for a port. The default
value is 0, so no auto recovery is possible; the port remains in shutdown forever mode. This requires
manual entry of the CLI command "config ports [ <portlist> | all ] state enable" to return the port to
a forwarding state. The default value is 0, which means disable auto recover mode, shutdown forever.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
<min 0> - Enter the automatic recovery time used here. This value will specifies the time to be 0
otherwise known as 'no recovery mode'.
<min 1-65535> - Enter the automatic recovery time used here. This value must be between 1
and 65535 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the auto recover time to 5 minutes:
DGS-3420-28SC:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
DGS-3420-28SC:admin#
65-3 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled, traffic
control states are logged when a storm occurs and when a storm is cleared. If the log state is disabled,
traffic control events are not logged.
The log state is only applicable for shutdown mode. Since shutdown mode only support broadcast and
multicast storm control, doesn't support unicast storm control. The log only generate for broadcast and
multicast storm control.
739