D-Link xStack DGS-3420 Series Reference Manual page 1057

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config wac virtual_ip {<ipaddr> | <ipv6addr>}
Parameters
<ipaddr> - Specifies the IPv4 address of the virtual IP.
<ipv6addr> - Specifies the IPv6 address of the virtual IP.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the WAC virtual IP address used to accept authentication requests from unauthenticated
hosts:
DGS-3420-28SC:admin# config wac virtual_ip 1.1.1.1
Command: config wac virtual_ip 1.1.1.1
Success.
DGS-3420-28SC:admin#
34-9 config wac switch_http_port
Description
This command is used to configure the TCP port which the WAC switch listens to. The TCP port for
HTTP or HTTPs is used to identify the HTTP or HTTPs packets that will be trapped to CPU for
authentication processing, or to access the login page. If not specified, the default port number for
HTTP is 80, and the default port number for HTTPS is 443. If no protocol is specified, the protocol is
HTTP.
Format
config wac switch_http_port <tcp_port_number 1-65535> {[http | https]}
Parameters
<tcp_port_number 1-65535> - Specify a TCP port which the WAC switch listens to and uses to
finish the authenticating process.
http - (Optional) Specify that WAC runs HTTP protocol on this TCP port.
https - (Optional) Specify that WAC runs HTTPS protocol on this TCP port.
1052