Config Scheduling - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
4 No Limit
5 No Limit
6 No Limit
7 No Limit
DGS-3420-28SC:admin#
5-5

config scheduling

Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling {ports [<portlist> | all]} <class_id 0-7> [strict | weight <value 1-127>]
Parameters
ports - (Optional) Specifies the range of ports to be configured.
<portlist> - Enter the list of ports here.
all - Specifies that all the ports will be used.
<class_id 0-7> - Specifies the 8 hardware priority queues that the config scheduling command will
apply to. The eight hardware priority queues are identified by a number from 0 to 7 with the 0
queue being the lowest priority.
strict - Specifies that the queue will operate in strict mode.
weight - Specifies the weight value for weighted round robin. The queue will operate in WRR mode if
the port mode is WRR. It will operate in strict mode if the port mode is strict.
<value 1-127> - Enter the weight value here. This value must be between 1 and 127.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic scheduling on CoS queue 0 with a maximum packet value of 10:
DGS-3420-28SC:admin#config scheduling 0 weight 10
Command: config scheduling 0 weight 10
Success.
DGS-3420-28SC:admin#
To configure the traffic scheduling on CoS queue 1, with a weight value of 25, on port 10:
DGS-3420-28SC:admin# config scheduling ports 10 1 weight 25
Command: config scheduling ports 10 1 weight 25
No Limit
No Limit
No Limit
No Limit
800