Show Stp Instance - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To display STP:
DGS-3420-28SC:admin#show stp
Command: show stp
STP Bridge Global Settings
---------------------------
STP Status
STP Version
Max Age
Hello Time
Forward Delay
Max Hops
TX Hold Count
Forwarding BPDU
New Root Trap
Topology Change Trap : Enabled
NNI BPDU Address
DGS-3420-28SC:admin#
16-2
show stp instance
Description
This command is used to display each instance parameters settings. Value means the instance ID, if
there is no input of this value, all instances will be shown.
Format
show stp instance {<value 0-64>}
Parameters
<value 0-64> - (Optional) Specify the MSTP instance ID. Instance 0 represents the default instance:
CIST. This value must be between 0 and 64.
Restrictions
None.
Example
To display STP instances:
: Disabled
: RSTP
: 20
: 2
: 15
: 20
: 6
: Disabled
: Enabled
: dot1d
899
Advertisement
Table of Contents
