D-Link xStack DGS-3420 Series Reference Manual page 730

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
63-19 config syslog source_ipif
Description
This command is used to force change the ipif information in syslogs. By default, syslogs will carry the
information of the ipif they belong to.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Specify the IP interface name. If only this parameter is specified, the IPv4 address
and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specify the IP4 address.
<ipv6addr> - (Optional) Specify the IPv6 global address.
none - Specify to clear the configured source IP interface.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the syslog source IP interface:
DGS-3420-28SC:admin#config syslog source_ipif Sysetm
Command: config syslog source_ipif System
Success.
DGS-3420-28SC:admin#
To clear the configured source IP interface for syslog:
DGS-3420-28SC:admin#config syslog source_ipif none
Command: config syslog source_ipif none
Success.
DGS-3420-28SC:admin#
63-20 show syslog source_ipif
Description
This command is used to display the syslog source IP interface.
725