Disable Qinq - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable Q-in-Q:
DGS-3420-28SC:admin#enable qinq
Command: enable qinq
Success.
DGS-3420-28SC:admin#
6-2
disable qinq
Description
This command is used to disable Q-in-Q. When Q-in-Q is disabled, all dynamic learned L2 addresses
will be cleared, all dynamic registered VLAN entries will be cleared, and GVRP will be disabled. To run
GVRP on the switch, the administrator should enable GVRP manually.
Format
disable qinq
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable Q-in-Q:
DGS-3420-28SC:admin#disable qinq
Command: disable qinq
Success.
DGS-3420-28SC:admin#
815
Advertisement
Table of Contents
