Show Ports - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3420-28SC:admin#
23-2

show ports

Description
This command is used to display the current configurations of a range of ports.
Format
show ports {<portlist>} {[description | err_disabled | auto_negotiation | details | media_type]}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
description - (Optional) Specify to display the port description.
err_disabled - (Optional) Specify to display disabled information.
auto_negotiation - (Optional) Specifies to display detailed auto-negotiation information.
details - (Optional) Specify to indicate if port detail information will be included in the display.
media_type - (Optional) Specify to display the current port media type and STP information. For FE
ports, the media type should be 100BASE-TX. For GE ports (the combo port), if the current active
port is the fiber port, the media type is 1000BASE-FX or 100BASE-FX; if the current active port is
the copper port, the media type is 1000BASE-T and SFP information is displayed when SFP is
existent.
Note: If no parameter is specified, all ports will be displayed.
Restrictions
None.
Example
To display the configuration of ports 1 to 4:
DGS-3420-28SC:admin#show ports 1:1-1:4
Command: show ports 1:1-1:4
Port State/
MDIX
------- --------
1:1 Enabled
Auto
1:2 Enabled
Auto
1:3 Enabled
Auto
Settings
Speed/Duplex/FlowCtrl
---------------------
Auto/Disabled
Auto/Disabled
Auto/Disabled
Connection
Speed/Duplex/FlowCtrl
----------------------
Link Down
Link Down
Link Down
956
Address
Learning
---------
Enabled
Enabled
Enabled