D-Link xStack DGS-3420 Series Reference Manual page 861

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
delete sflow analyzer_server <value 1-4>
Parameters
<value 1-4> - Specify a value between 1 and 4.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete the sFlow analyzer server 1:
DGS-3420-28SC:admin#delete sflow analyzer_server 1
Command: delete sflow analyzer_server 1
Success.
DGS-3420-28SC:admin#
12-9 config sflow analyzer_server
Description
This command is used to configure the sFlow analyzer server information. More than one collector
with the same IP address can be specified if the UDP port numbers are unique.
Format
config sflow analyzer_server <value 1-4> {timeout [<sec 1-2000000> | infinite] |
collectoraddress [<ipaddr> | <ipv6addr>] | collectorport <udp_port_number 1-65535> |
maxdatagramsize <value 300-1400>}(1)
Parameters
<value 1-4> - Enter the analyser server ID used here. This value must be between 1 and 4. The
switch supports 4 different analyser servers at the same time. Each sampler or poller can select a
server ID (1, 2, 3, or 4) to send the samples.
timeout - (Optional) Specify the time (in seconds) remaining before the sample is released and stops
sampling. When the analyzer_server times out, all of the flow_samplers and counter_pollers
associated with this analyzer_server will be deleted. If it is specified as infinite, the server will
never be timeout.
<sec 1-2000000> - Specify the time out value, in seconds, between 1 and 2000000.
infinite - Specify to never time out.
collectoraddress - (Optional) Specify the IP address of the server.
<ipaddr> - Specify the IP address of the server. If set to 0, sFlow packets will not be sent to this
server.
856