D-Link xStack DGS-3420 Series Reference Manual page 427

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To rename a file or directory:
DGS-3420-28SC:admin#rename run.had run1.had
Command: rename run.had run1.had
Success.
DGS-3420-28SC:admin#
35-7 erase
Description
This command is used to delete a file stored in the file system. The system will prompt if the target file
is a bootup image/configuration or the last image.
Format
erase {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the file to be deleted. If it is specified in the associated form, then it is
related to the current directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a file:
DGS-3420-28SC:admin#erase cfg
Command: erase cfg
Are you sure to remove the boot up Configuration from this device? (y/n)y
Success.
DGS-3420-28SC:admin#
422