D-Link xStack DGS-3420 Series Reference Manual page 1014

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
30-4 config vrrp vrid
Description
This command is used to configure the virtual router settings by VRID.
Format
config vrrp vrid <vrid 1-255> ipif <ipif_name 12> {state [enable | disable] | priority <int 1-254> |
ipaddress <ipaddr> | advertisement_interval <int 1-255> | preempt [true | false] | critical_ip
<ipaddr> | critical_ip_state [enable | disable]}
Parameters
vrid - specifies the ID of the Virtual Router used.
<vrid 1-255> - Enter the Virtual Router ID used here. This value must be between 1 and 255.
ipif - Specify the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
state - (Optional) Specify the state of the virtual router function.
enable - Specify that the virtual router function will be enabled.
disable - Specify that the virtual router function will be disabled.
priority - (Optional) specifies the priority to be used for the Virtual Router Master election process
<int 1-254> - Enter the priority value used here. This value must be between 1 and 254.
ipaddress - (Optional) Specify the virtual router's IP address used.
<ipaddr> - Enter the virtual router's IP address used here.
advertisement_interval - (Optional) Specify the time interval used between sending advertisement
messages.
<int 1-255> - Enter the advertisement interval value here. This value must be between 1 and 255
seconds.
preempt - (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within the same
VRRP group. Default is setting is true.
true - Specify that if the backup router's priority is set higher than the masters priority, it will
become the master instead of the current one.
false - Specify if the backup router's priority is higher than the masters priority, it will not become
the master until the master failed.
critical_ip - (Optional) specifies an IP address that will provide the most direct route to the Internet or
other critical network connections from this virtual router. This IP address must be a real IP
address of a real device on the network. If the connection from the virtual router to this IP address
fails, the virtual router will automatically be disabled. A new Master will be elected from the backup
routers participating in the VRRP group. Different critical IP addresses may be assigned to
different routers participating in the VRRP group and can therefore define multiple routes to the
Internet or other critical network connections.
<ipaddr> - Enter the critical interface's IP address used here.
critical_ip_state - (Optional) Specify the state of checking the status (active or inactive) of a critical
IP address.
enable - Specify that the critical IP state checking will be enabled.
disable - Specify that the critical IP state checking will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
1009