D-Link xStack DGS-3420 Series Reference Manual page 142

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3420-28SC:admin#
eth-bc ethernet source_mac FF-FF-FF-FF-FF-FF
Command: create egress_access_profile profile_id 1 profile_name eap-eth-bc ethernet
source_mac FF-FF-FF-FF-FF-FF
DGS-3420-28SC:admin#
6-2 delete egress_access_profile
Description
Delete egress access profile command can only delete the profile which is created by egress ACL
module.
Format
delete egress_access_profile [profile_id <value 1-4> | profile_name <name 1-32> | all]
Parameters
profile_id - Specifies the index of the egress access list profile.
<value 1-4> - Enter the profile ID used here. This value must be between 1 and 4.
profile_name - Specifies the name of the profile. The maximum length is 32 characters.
<name 1-32> - Enter the profile name used here. This name can be up to 32 characters long.
all - Specifies that the whole egress access list profile will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete egress access list profile ID 1:
DGS-3420-28SC:admin#
Command: delete egress_access_profile profile_id 1
Success.
DGS-3420-28SC:admin#
6-3 config egress_access_profile
Description
This command is used to configure egress access list entries.
create egress_access_profile profile_id 1 profile_name eap-
delete egress_access_profile profile_id 1
137